Randy & Travis’ heavy duty rubber cable and electrical dual channel wire cover and protector will keep your wiring safe from solids and liquids, as well as from traffic up to 20,000 pounds per axle.
This cable protector ramp is easy to set up and use, eliminating the safety challenge posed by bulging hose lines, crushed cables, and pinched electrical wires in high-traffic areas. With a modular design that connects multiple ramps, these ramps make it possible to protect longer cable lengths.
The dual channels are accessible through a PVC lid with written electrical safety warnings in writing and with international safety symbols. This system works equally well indoors and out to protect your cables and those who cross over them. Made from commercial-grade, heavy-duty thermoplastic rubber, these ramps have a non-slip base that stands up under sunlight, while their sloping sides make it easy for carts and other wheeled vehicles to pass over.
The easy-to-use snap fit cable protectors allow you to snap the ramp open, slide in the cables, and put the protector on the floor. Should there be a fire, this cable protector emits no harmful gases and a low smoke emission level.
Perfect for exhibition halls, festivals, factories, offices, retail shops, and warehouses, these cable protectors are a must-have item for many businesses and organisations.
- Type: Dual channel
- Wire gauge: PVC and rubber
- Model: 2-slot
- Conductor material: Rubber
- Protects against: Solids and liquids
- Minimum operating temperature: -4 degrees Celsius
- Maximum operating temperature: 55 degrees Celsius
- Colour: Black and yellow
- Each section length: 1 m
- Dimensions: 100 cm x 25 cm x 5 cm
- Channel dimensions: 33 mm x 30 mm
Note: Included in your purchase is 3 x 1m Lengths